Henseleit 3DNT in excellent and original condition.  This helicopter has never been crashed (!) and the care with which I built the model and the small amount of flying that it has done will both be apparent when you see the model.

The model was built just before the 3D Masters 2003 and is exactly as per Jan Henseleit’s specification with the addition of a uniflow fuel setup – something which could be removed in a couple of minutes if you wanted.

The helicopter is completely ready to fly and is fitted with the following equipment…

• Henseleit 3DNT Helicopter

• OS MAX 91FX-HGL (Rev)

• Tuned pipe: Hatori 700 with NT manifold

• Lötterle carb

• 3 x Futaba S 9206 cyclic servos (9,5 kg/cm at 4,8 Volts)

• Futaba 9001 throttle servo

• Futaba S9251 tail servo

• Futaba GY 601 gyro

• Futaba 149DP 9 channel PCM receiver

• Sanyo 1700 mAh receiver battery

• NHP Razor Pro blades 710mm

I will include a starter fitted with the correct Henseleit starter adaptor three gallons of fuel to get you started.    I can of course demonstrate the helicopter for anyone who is seriously interested in buying it.

You can find out more information about this stunning helicopter on the Revolution Models website at http://www.revolutionmodels.co.uk/3dNt.htm

You can contact me at +44 (0)7980 445499 or by e-mail at